32
Network Camera User Manual
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial for line crossing detection.
4.5.3
Intrusion
Intrusion
: Alarms will be triggered if the target intrudes into the pre-defined areas. This
function can be applicable to important supervision places, danger areas and prohibited areas,
like military administrative zones, high danger areas, no trespassing areas, etc.
Go to Config
→
Event
→
Intrusion interface as shown below.
1. Enable intrusion detection and select the snapshot type and the detection target.
Save Panoramic Picture
: If it is enabled, the detected panoramic pictures will be captured and
saved to the SD card when the targets intrude into the pre-defined areas.
Save Target Cutout
: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when the targets intrude into the pre-defined areas.
Note
: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the
local config interface first. To save snapshots to the SD card, please install an SD card first.
Detection Target
:
Human:
Select it and then alarms will be triggered if someone intrudes into the pre-defined
area.
Motor Vehicle
: Select it and then alarms will be triggered if a vehicle with four or more wheels
(eg. a car, bus or truck) intrudes into the pre-defined area.
Motorcycle/Bicycle
: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) intrudes into the pre-defined area.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if intrusion
Summary of Contents for Transcendent VTC-TNB8RFA3-2
Page 2: ......
