7
2. Bypass Assembly Connection: Install the bypass valve onto the main control
valve using the H clips before beginning plumbing. (See Fig. N or O)
3. The installation of the water softener must be carried out in accordance with state, local and provincial
plumbing codes.
4. The control valve, fittings and bypass assembly are designed to accommodate minor plumbing
misalignments. There is a small amount of “give” to properly connect the piping but the water softener
is not designed to support the weight of the plumbing.
Do not use Vaseline oils, other hydrocarbon lubricants or spray silicone anywhere. A food grade
silicone lubricant may be used only on O-rings.
5. Do not use pipe dope or other sealants on threads. Teflon tape should be used on the threads of the ¾”
inlet and outlet ports on the bypass assembly. Fittings to connect ¾” or ½” copper pipe or ¾” or
½” pex pipe to the bypass assembly are not supplied.
6. The diagrams below show a well installation and municipal installation.
The power adapter cord (Fig 4.) should be connected to the
valve cable power connector (Fig 5.) shown on the right:
Water T
echnologies
Water T
echnologies
Municipal Water Installation
Well Water Installation
Fig 1.
Fig 2.
Fig 4.
Fig 3.
Fig 5.
LCD display connector (connect to top cover)
i
nsTallaTion
i
nsTruCTions
(
ConTinued
)
1. Place the cabinet around the tank and valve head assembly
and connect the white 3/8” tubing to the brine tank using
the quick connect as shown in Fig 1. Then LCD display
connector from valve should be connected to LCD display
connector from the cover as shown in Fig 2 & 3.
