Vislink HDR-5000, User And Technical Manual

Page: 32 / 47

26 HDR-5000 User and Technical Manual
3.8 TSoIP Endpoint
The Transport Stream over Internet Protocol (TSoIP) sets the destination of the video signal across the IP
network and the HDR-5000 will stream Video over IP based on its settings. The TSoIP settings that you
can control are as follows:

Encapsulation Type: UDP or RTP

RTP Only settings:

Forward Error Correction (FEC) Enable: choice of On or OFF

FEC Number of columns: 1-20 columns

FEC Number of rows: 4-20 rows

Stream Enable: choice of On or Off

Destination IP: IP address of the intended or target receiver

UDP Port: Defines the port address of the intended receiver.
The TSoIP Endpoint Web interface is shown in the figure below.
Figure 3-10. TSoIP Endpoint Page
3.8.1 Edit Transport Stream over IP (TSoIP) Definition
The Edit TSoIP Definition provides a means to select the Transport Stream over IP parameters when
you use the drop-down menu. You can also click the Create New button to set up an alternate target IP
address and port via UDP or RTP to send video signals across the IP network.
3.8.2 Parameters
The Parameters section provides the following entry fields when you choose the Create New option:

Target IP—The address for the transport stream.

Target Port—The port for the transport stream.

Protocol—UDP or RTP

FEC Rows—The number of rows (4-20)

FEC Columns—The number of columns (1-20)

FEC Enable—Forward Error Correction Enable allows selection of either On or Off and the
selection of FEC rows and columns.
The Delete TSoIP button deletes the displayed endpoint and Save Changes allows you to save any
modifications.