Vislink HDR-5000, User And Technical Manual

Page: 24 / 47

18 HDR-5000 User and Technical Manual
3.3.11 TSoIP 1 and 2 Configuration
The Transport Stream over Internet Protocol (TSoIP) sets the destination of the video signal across
the IP network and the HDR-5000 is set to convert ASI to IP, HDR-5000 then streams over IP to the
defined IP Address and Port. The primary and the secondary TSoIP settings that you can view are as
follows:
TSoIP Name
The TSoIP Name can be set in the TSoIP Endpoint page. You name the unique primary and the
secondary TSoIP.
Destination
The Destination IP address is also set in the TSoIP Endpoint page. When you define a port, this will be
shown in the IP address.
FEC Enable
FEC Enable is also set in the TSoIP Endpoint page. When you enable Forward Error Correction, this will
be indicated.
Select TSoIP
The Select TSoIP drop-down menu appears when a TSoIP Endpoint is enabled. You can disable the
TSoIP for one or both of the primary or the secondary TSoIP Endpoints.
3.4 Presets Page
All of the configurable control of the HDR-5000 can be stored within a preset to be recalled at any time
during routine operation. An unlimited array of presets can be saved and accessed using the Web
interface. Each preset encompasses:

TSoIP configuration

Encryption settings

BDC selection (dictating available frequencies)

Frequency channel selection (providing a choice of reception frequency)
NOTE:
You can change any of these parameters on the radio independently, at which
point they will no longer be included within a specific preset, but instead in a
manual mode of operation. However, on next reboot, the system recalls the last
state of the radio, whether it is in a preset, or modified preset mode.
While viewing a Dashboard or Status page, click the Setup button at the top of the page to display the
Presets page. The Setup menu appears allowing selection of the following options:

Presets

BDC

Channel Plans

Encryption Keys

TSoIP Endpoint

System Settings
3.4.1 Edit Presets Definition
The drop-down displays the current preset. You can edit the current preset or select another preset from
the list. Also you may click the
Create New button to create an HDR-5000 preset with a new and unique
set of parameters.