Vision 2310b, Instruction Manual, Page: 44 / 48

41
© 2007 KIRAMEK, INC.
TROUBLESHOOTING
CAN’T MAKE SIREN GO OFF AFTER ARMING
You may have Armed using the Sensor Bypass Method. See page 28.
•
You may have Armed using Silent Mode. See page 27.
•
If you Armed using the Normal Method, did you hear a single chip when
•
you Armed the system? If not, the Ignition may be on. You
cannot Arm
the system when the Ignition is ON while “IG Protect Mode” is active.
See page 32 for details on IG Protect Mode.
FULL SIREN GOES OFF WITH ONLY LIGHT IMPACT TO THE VEHICLE.
If you are using the optional 318-04 Ultrasonic Sensor along with the
included 318-052 IR Shock Sensor, it is likely that the two sensors (the
main body of each sensor) were installed too close together. They must
be separated by more than 30cm (1 ft.) or interference will cause false
triggering of the siren.
If you do not have the Ultrasonic Sensor installed, try adjusting sensitiv-
ity of your shock sensor. If that doesn’t work, you will need to snap open
the housing of the shock sensor and verify if the suspended reflector has
been jolted out of position (see bottom of page 23 for details).