Vision 2310b, Instruction Manual, Page: 37 / 48

34
FEATURE PROGRAMMING
To program features, have your vehicle’s key ready to turn the ig-
nition (IG) “on-and-off” several times. ( TIP: Use the “ACC” posi-
tion as IG “off” because its easier to switch.) Perform the following
3-step procedure to alter the features shown in Table-1 below:
Disarm
1.
the system.
(Or “Arm-then-Disarm” if repeating this procedure.)
Turn
2.
IG on-and-off the same number of times as the feature you wish to
program
(refer to “No.” in
Table-1
below), within 20 sec. of disarming .
(For example, if you want to change “Auto Arm,” you must turn the IG
on-and-off 8 times within 20 sec.)
Push 3. Button-1 on the transmitter. (Your chosen setting has toggled.
The Status LED will then flash the same number of times as the fea -
ture you just programmed. Your programming session is now finished.)
W hen the Status LED stops flashing in Step-3 above, you can program
another feature only by restarting this procedure at Step-1.
TABLE-1 Feature Selection Menu
No. Feature Description Toggle Settings
3 IG Protect Mode / Idling Compatibility Mode
IG Protect
Idling
4 Turn On Lights When Engine Idling
OFF
ON
8 Auto Arm
OFF
ON
10 Auto Rearm
OFF
ON
17 Exterior Illumination
OFF
ON
20 Transmitter Learning & Manual Disarm Code See page 36.
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
OPERATION
NOTES:
(1)
The Status LED will flash the same number of times as the
feature you just programmed but there will be no indication of the chosen
Toggle Setting—test your 2310 system to confirm your programming.
(2) There is no “reset to factory default” feature.
(3) Don’t perform Step-3 when choosing No. 20 in Table-1 below. See pg. 36.