Vision 2310b, Instruction Manual, Page: 39 / 48

36
VISION 2310B INSTRUCTION MANUAL
PROGRAM FEATURES EXPL AINED
When set to OFF (default), vehicle lights (hazards) will not illuminate after
disarming.
When set to
ON
, vehicle lights (hazards) will flash 3 times upon disarming
and then light solid for 30 seconds (or until the Ignition switch is turned
on) to illuminate the area surrounding the vehicle for greater security.
17 Exterior Illumination
Refer to the three-step Feature Programming section on page 34. It is
important to note that you
do not perform Step-3
when selecting this fea-
ture.
When you turn the Ignition on-and-off 20 times in Step-2 , you can then
select one of two features:
To choose Manual Disarm Code
, you must wait and turn the Ignition on
again (for the 21st time) when the hazard lights finish flashing 20 times,
and then leave the Ignition on. Complete steps given on page 37 .
To choose Transmitter Learning , you must leave the Ignition turned
off (no need to turn it on for the 21st time).
Complete steps given on page
39.
The Transmitter Learning feature allows you to add new transmitters to
your system. The Manual Disarm Code feature allows you to program a
unique code that will allow you to disarm the system even without your
remote.
The factory default Manual Disarm Code is “6,” but you should
change this as soon as possible to your own unique code for greater secu-
rity.
20 Transmitter Learning & Manual Disarm Code