Vision 2310b, Instruction Manual, Page: 35 / 48

32
VISION 2310B INSTRUCTION MANUAL
SYSTEM “ARMED” FEATURES
IIP (Intelligent Ignition Protect)
IG PROTECT MODE
(enabled by default)
When the ignition goes on while the system is armed, the si-
ren will go off for 30 seconds. Vehicle lights will flash if so in -
stalled.
(See page 34 for programming.)
IDLING COMPATIBILITY MODE
When the ignition goes on while the system is armed, the
siren will not go off. Instead, shock sensor and ignition triggers
are bypassed while door and trunk/hatch triggers remain active.
(See page 34 for programming.)
Idling Compatibility Mode allows the driver to leave the engine idling
and Arm the security system. Even though the ignition is on in this situa-
tion, the 2310 is still protecting the vehicle and any attempt to open a door
or the trunk/hatch will trigger the siren. And when the ignition is turned
off, the shock sensor and ignition triggers are then re-activated.
IIP is a unique VISION security feature that intelligently switches as need-
ed between 2 modes: IG Protect Mode & Idling Compatibility Mode .
ON ST
ACC
OFF
Why IIP is Needed.
Most competing alarms bypass all trigger inputs
when the ignition goes on while armed: so if a thief opens a door the siren
will go off, but the thief can then close the door, turn on the ignition and
wait; when the siren stops, he can drive away in silence because the Igni-
tion-ON state prevents the siren from going off again!
Yet other competing
alarms trigger the siren when the ignition goes on while armed, but such
prevents arming with the engine idling (with IG on). IIP solves this “com-
patibility versus security” problem.
How IIP Works.
If the ignition (IG) is turned on in Idling
Compatibility Mode
, the siren will not go off because IG
is bypassed; but sectors other than IG can still trigger the
siren. However, if the siren was triggered before IG was
turned on (via door, trunk, etc.), IIP switches back to IG
Protect Mode and will trigger the siren if IG is later turned on.
PROGRAMMABLE