Vision 2310b, Instruction Manual, Page: 22 / 48

VISION 2310B INSTRUCTION MANUAL
19
IMMOBILIZER HARNESS
H3
H3-10&11 Immobilizer Relay#2 – Ignition Coil
H3-08&09 Immobilizer Relay#1 – Starter Motor
Wire-08 and Wire-09 of the H3 harness (see page 7) lead to an internal
“ Normally Open ” 20-Amp relay inside the 2310 control module. To immo-
bilize the Starter motor with these two wires, connect as shown in
Fig-13
below.
Wire-10 and Wire-11 of the H3 harness (see page 7) lead to an internal
“
Normally Open
” 20-Amp relay inside the 2310 control module. To im-
mobilize the Ignition Coil with these two wires, connect as shown in Fig-14
on the next page.
WARNING!
DO NOT PROCEED with the wiring shown on this page
or the next page without first having completely read pages 17 & 18.
1
IGNITION
SWITCH
OFF
ACC
ON
ST
ST
9
8
NOTE: It doesn’t matter if 8 & 9 are reversed.
FIG-13: Immobilizing the STARTER
H3