EN - 36
Legend ‘70s
– User Manual
Modifying a Program
EQ Low Gain
Set the gain (positive value) or attenuation (negative values) of the low frequencies generated by
the effect.
Values:
between -12.0 and +12.0 dB
EQ High Gain
Set the gain (positive value) or attenuation (negative values) of the high frequencies generated by
the effect.
Values:
between -12.0 and +12.0 dB
Dry/Wet
Balance between the effect's original input signal (
Dry/Wet
=0.0) and the effected signal
(
Dry/Wet
=10.0).
Values:
between 0.0 and 10.0
Wah
This effect is a filter that changes frequency, modulating the sound's brilliance. There are three kinds of Wah:
Control Wah
modulates the sound through a continuous control device, such as a pedal connected to the [FOOT CONTROLLER 1] or
[FOOT CONTROLLER 2] ports, the modulation wheel or the [RATE] knob.
Auto Wah
automatically modulates the sound in a
cycle.
Touch Wah
modulates the signal according to the signal level (a higher level sweeps up the effect it's open sound,
corresponding to the "rocked forward" position).
Parameter name
Description
Switch
[FX ON]
Activate / deactivate effect.
Values:
OFF, ON
FX Config
FX Out Routing
Reverb Send
Same function of the parameters described at page
Wah Type
Wah type.
Values:
Control, Auto, Touch
Top
Maximum filter frequency.
Values:
between 0.0 and 10.0
Bottom
Minimum filter frequency.
Values:
between 0.0 and 10.0
Resonance
[AMOUNT]
Resonance of the filter determining the boost of the frequencies surrounding the cutoff frequency.
Values:
between 0.0 and 10.0
Filter Type
Filter type.
Values:
LP (low-pass), BP (Band-pass), HP (high-pass)
LFO Speed
(Auto Wah)
[RATE], [TAP]
If the Sync parameter = OFF
Modulation frequency.
Values:
between 0.0 and 10.0
If the Sync parameter = ON
Time signature used to calculate the modulation frequency, based on metronome tempo set
through the
Master
Clock parameter on the
COMMON
).
Values:
1/1, 1/2D, 1/1T, 1/2, 1/4D, 1/2T, 1/4, 1/8D, 1/4T, 1/8, 1/16D, 1/8T, 1/16, 1/16T, 1/32,
1/64
NB
D : dot
T: triplets
Sensitivity
(Touch Wah)
[RATE]
Sensitivity to the keyboard velocity (and therefore signal level).
Values:
between 0.0 and 10.0
Control
(Control Wah)
[RATE]
Continuous control position.
Values:
between 0.0 and 10.0
Sync
(Auto Wah)
Synchronisation between the modulating signal and metronome tempo, as set through the
Master
Clock
parameter of the
COMMON
Values:
OFF, ON
EQ Low Gain
Set the gain (positive value) or attenuation (negative values) of the low frequencies generated by
the effect.
Values:
between -12.0 and +12.0 dB
EQ High Gain
Set the gain (positive value) or attenuation (negative values) of the high frequencies generated by
the effect.
Values:
between -12.0 and +12.0 dB
NB
When using the Control Wah the function FX1 or FX2 RATE (page
) must be assigned to the pedal that controls the
Wah.
Summary of Contents for Legend '70s Artist
