Viro RAM-TOUCH, User Manual

Page: 69 / 94

Page
67
of
88
User manual
Opening the door with a digital fingerprint if
both fingerprints and codes are present in
the memory
Opening the door with a fingerprint
Turn on the reader by pressing OK. The display will show:
The LEDs will start to flash in sequence from top to bottom, showing that the
system is ready to read a fingerprint. The speed at which the green LEDs flash is
the correct speed at which to swipe your finger in the guide channel from top to
bottom, applying slight pressure as if pressing down adhesive tape.
The display will show messages that make it possible to follow the various phases
of the opening procedure and any reasons for incorrect finger swiping (e.g. too
fast, too slow, crooked finger, etc.).
The swiped fingerprint will be compared with all the positions in the memory, so,
if swiped correctly, a single swipe on the reader is sufficient to open the
safe/cabinet, regardless of which position the fingerprint is stored in.
Recognition of the fingerprint releases the mechanism that allows the safe/cabinet
to be opened by turning the knob. The display will show:
turn the knob one quarter of a turn in a clockwise direction and open the door.
Note: if the knob is not turned within a few seconds, the mechanism is
blocked for safety reasons and the safe/cabinet remains closed. To open
it, it is necessary to start from the beginning again.
If the fingerprint is not recognised, for example because the finger was not
correctly swiped, a second attempt can be made; if the second attempt is also
incorrect, the system will switch off and it is necessary to start from the beginning
again.