42
Duplicator 3.37
17.AUTOCOPY
Counter:
No Counter
Preparing...
Please Wait
OK: 0 NG: 0 NB: 0
Input Bin > Drive01
Processing...
Please Wait
OK: 0 NG: 0 NB: 0
Input Bin > Drive02
Fill the input bin with the required number of blank discs
Place the Master disc on top of the stack in the input bin
Execute
the
AUTOCOPY
function
Fill the input bin with blank discs. Place the Master disc on top of the stack
of blank discs on the input bin, and press the
ENT/Enter
button. You will
then see the
Counter Selection
menu.
Follow the instructions shown in
“Setting Counters”
on page 14 to continue.
Once the counter has been set, press the
ENT/Enter
button to confirm. You
will then see the
Preparing
screen:
After a short interval, the robotic loader will pick the top disc (the Maser Disc)
from the input bin and place it into one of the drives. As this is happening,
you will see a screen similar to below:
This information screen shows what is happening. In this case, the loader
has taken a disc from the input bin and is placing it into Drive 1.
The loader will perform the loading process which will transfer the content of your master disc into the
reserved partition of the hard drive.
Upon the successful loading process, the system will drop the Master Disc
onto the output bin. It will then pick up the blank discs from the input bin and
place those into drives until either all of the drives are full, or the count that
you loaded into the counter is reached.
It takes a few seconds for the autoloader to recognize all the discs.
After two or three seconds of processing time, one of the following
Copy Progress
screens will appear.
Counter Specified
No Counter Specified
Copying... H4012MB
0/21 12% 481MB
or:
Copying... H4012MB
0 12% 481MB
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity of
the master disc.
“12%”/”481MB” indicates the
current progress of the duplication.
“0/21” indicates you have a project
size of 21 copies and you have
made 0 copies so far.
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity
of the master disc.
“12%”/”481MB” indicates the
current progress of the
duplication.
“0” indicates you have made 0
copies so far.
Note:
It is normal to see the progress indicator stay at 0%-10% and 100% for approximately 30
seconds for CD duplication and up to one minute for DVD/Blu-Ray Disc duplication. That is caused
by the initializing and finalizing stages.
Once the duplication run is completed, the loader will remove the finished
disc from a drive and place the successful copy on the output bin or if it is a
bad/NG copy, place it on the reject area. This will repeat for each drive.
The loader will then pick up another blank disc and load it into the drive. This is then repeated for each drive.
OK: 3 NG: 0 NB: 0
Drive01 -> Output Bin