Termoscanner
66
EN
Please refer to temperature measurement settings chapter for details.
6.3.3
-
SD Card Error
When there are some errors in writing to the SD card, the corresponding alarms will be triggered.
1. Go to Config
Alarm
Exception
SD Card Error as shown below.
2 - Click “Enable” and set the alarm holding time.
3 - Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same astemperature measurement settings. Please refer to
temperature measurement settings chapter for details.
6.3.4
-
IP Address Conflict
1. Go to Config
Alarm
Exception
IP Address Collision as shown below.
2. Click “Enable alarm” and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of other devices, the system will trigger the alarm out.
6.3.5
-
Cable Disconnection
1. Go to Config
Alarm
Exception
Cable Disconnected as shown below.
2. Click “Enable” and set the alarm holding time.
3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.
6.3.6
-
Alarm In
To set sensor alarm (alarm in): Go to Config
Alarm
Alarm In interface as shown below.
