Termoscanner
57
EN
Unlocking Mode
: four options--by face recognition, normal temperature, mask on, by password. Please check as needed.
By Face Recognition
: if the capture face picture is successfully matched, the door can be unlocked.
Normal Temperature
: if the temperature of the person measured is normal, the door will be unlocked.
Mask On
: if there is a mask on the face of the detected person, the door will be unlocked.
By Password
:enable and set the password here. Then tap
on the screen of the terminal, and enter the password you set to open the door.
Unlocking Delay Time
: Set the door unlocking delay time. The time range is from 0 to 10 seconds. For example, “By Face Recognition” is selected and
the delay time is set to “2” seconds; the door will be opened 2 seconds later after face recognition.
Unlocking Duration
: If the door has been unlocked for a period that exceeds the duration, the door will be automatically locked. The time range is from
0 to 10 seconds. For example, “By Face Recognition” is selected and the duration is set to “3” seconds; the unlocking door will be automaticallylocked 3
seconds later.
5.2 - Wiegand Settings
Click Config
Access Control
Wiegand Config to go to the following interface.
Alarm Trigger Mode
:
Wiegand Input, Wiegand Output or Off can be selected.
If the card reader is connected to the Wiegand interface, please select “Wiegand Input”.
If the access controller is connected to the Wiegand interface, please select “Wiegand Output”.
5.3 - Tampering Alarm Settings (Tamper).
In order to avoid the removal or damage by the external force, the tampering alarm can be set for the terminal.
Click Config
Access Control
Tampering Alarm Setting to go to the following interface.
Enable “Tampering Alarm” and then set the alarm holding time and alarm trigger options. The setup steps of the alarm trigger options are the same
astemperature measurement settings. Please refer to temperature measurement settings chapter for details.