Termoscanner
60
EN
3 - Set schedule recording. Check “Enable Schedule Record” and set the schedule..
Week Schedule
Set the alarm time from Monday to Sunday for a single week. Each day is divided in one hour increments. Green means scheduled. Blank means
unscheduled.
“Add”: Add the schedule for a special day. Drag the mouse to set the time on the timeline.
“Erase”: Delete the schedule. Drag the mouse to erase the time on the timeline.
Manual Input
: Click it for a specific day to enterspecific start and end times. This adds more granularities (minutes).
Day Schedule
Set the alarm time for alarm a special day, such as a holiday.
Note: Holiday schedule takes priority overweekly schedule.
Snapshot Settings:
Go to Config
System
Storage
Snapshot to go to the interface as shown below.
Set the format, resolution and quality of the image saved on the SD card and the snapshot interval and quantity and the timing snapshot here. Snapshot
Quantity
: The number you set here is the maximum quantity of snapshots. The actual quantity of snapshots may be less than this number. Supposing
the occurrence time of an alarm event is less than the time of capturing pictures, the actual quantity of snapshots is less than the set quantity of snap
-
shots.
Timing Snapshot
: Enable timing snapshot first and then set the snapshot interval and schedule. The setup steps of schedule are the same as the
schedule recording (See Schedule Recording).
USB disk
: This function is only available for the model with USB interface. In this interface, you can view the state and capacity of the USB flash disk.
