Termoscanner
65
EN
1 - Enable the applicable detection that’s desired.
Scene Change Detection
: Alarms will be triggered if the scene of the monitor video has changed.
Video Blur Detection
: Alarms will be triggered if the video becomes blurry.
Enable Video Color Cast Detection
: Alarms will be triggered if the video becomes obscured.
2 - Set the alarm holding time.
3 - Set the sensitivity of the exception detection.
Drag the slider to set the sensitivity value or directly enter the sensitivity value in the textbox. Click “Save” button to save the settings.
The sensitivity value of Scene Change Detection
: The higher the value is, the more sensitive the system responds to the amplitude of the scene
change.
The sensitivity value of Video Blur Detection
: The higher the value is, the more sensitive the system responds to the blurriness of the image.
The sensitivity value of Video Color Cast Detection
: The higher the value is, the more sensitive the system responds to the obscuring of the image.
Alarm out
: If selected, this would trigger an external relay output that is connected to the camera on detecting the video exception.
Trigger SD Snap
: If selected, the system will capture images when detecting the video exceptionand save the imageson an SD card.
Trigger SD Recording
: If selected, video will be recorded on an SD card when detecting the video exception.
Trigger Email
: If “Trigger Email” and “Attach Picture”are checked (email address must be set first in the Email configuration interface), the captured
pictures and triggered event will be sent into those addresses.
Trigger FTP
: If “Trigger FTP” is checked, the captured pictures will be sent into FTP server address. Please refer to FTP configuration chapter for more
details.
4 - Click “Save” button to save the settings.
6.3.2
-
SD Card Full
1 - Go to Config
Alarm
Exception
SD Card Full.
2 - Click “Enable” and set the alarm holding time.
3 - Set alarm trigger options. The setup steps are the same astemperature measurement settings.
