Villager VLP 1610, Manual, Page: 27 / 137

11
Chisel Function
For chiseling, press the button (7) on the selector switch (3) and simultaneously turn the
selector switch (3) to position 7 (A.4-3). In switch position 7 (A.4-3) the chisel is not locked.
– Insert the chisel into the tool holder.
– Turn the mode selector switch to the 7 (A.4-3) position.
– Turn the tool holder to the desired chiselling position.
For chiseling, press the button (7) on the selector switch (3) and simultaneously turn the
selector switch (3) to position . The chisel is locked in position .
HOW TO USE THE HAMMER
1. After placing the tip of in the base hole switch ON. In some cases Iit is necessary to
punch the up of the bit against the crushing position forcibly in order to begin the
striking stokes. This is not due to malfunction of the tool. It means that the safe guard
mechanism against no-load striking is working.
2. By utilizing the weight of the machine and by firmly holding the hammer with both
hands, one can effectively control the subsequent recoil motion. Proceed at a
moderate mark-rate, the use of too much force will impair efficiency.
CLEANING, MAINTENANCE
Important!
Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device immediately each time you have finished
using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use
cleaning agents or solvents; these
could attack the plastic parts of the equipment.
•
Ensure that no water can seep into the device.
The hammer must be lubricated with grease after approximately 40-45 hours of operation.
Using a cam spanner , remove the cap from the top of the Machine.
Lubricate all accessible mechanical parts with approx. 50 g of grease.