© 2011 Viking Preferred Service
112
Service Diagnostics and Procedures
Bake Element
The unit uses a single pass outer element and eight
pass inner element to achieve the bake function.
To access Bake Element:
1.
Remove oven door
(see Door Removal section,
page 107).
2.
Remove screws and lift kick plate from keyhole
screws.
3.
Remove keyhole screws and lower access grill
from range.
4.
Remove screws and bake tray cover.
5.
Remove bake element insulation from range.
Note:
Use care with insulation, make sure to
replace any damaged or missing insulation.
6.
Remove screws and slide bake element tray
forward to gain access to connectors.
7.
Mark and disconnect four connectors from
bake element.
8.
Remove bake element from range.
9.
Reverse procedure for installation.
Note:
VDSC530 shown (VDSC548 has a left and
right bake element).
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Service Diagnostics and Procedures–Disassembly
Screws
Kick Plate
Screw
Screw
Bake Tray Cover
Lower Access Grill
Keyhole Screws
Bake Element Insulation
Screws
Bake Element Tray
Connectors
Connectors
Summary of Contents for VDSC530 Series
Page 124: ...Wiring and Schematics Wiring Schematic VDSC530T 4B 124 2010 Viking Preferred Service ...
Page 125: ... 2010 Viking Preferred Service 125 Wiring and Schematics Wiring Schematic VDSC536T 4G ...
Page 126: ... 2010 Viking Preferred Service 126 Wiring and Schematics Wiring Schematic VDSC536T 4Q ...
Page 127: ... 2010 Viking Preferred Service 127 Wiring and Schematics Wiring Schematic VDSC536T 6B ...
