© 2011 Viking Preferred Service
89
Service Diagnostics and Procedures
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution.
DO NOT
USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
Landing Ledge– VDSC536T (continued)
5a. VDSC536-4G: disconnect griddle electronic
thermostat wires and connectors.
5b. VDSC536-4G: if griddle module needs replacing,
remove securing screws from front of control
panel and then remove and replace griddle
module.
6.
If the control board needs replacing, remove
screws securing oven control to the landing
ledge
(shown below)
. If only removing landing
ledge to access other components, simply
unplug the two wires to the oven light switch
and place landing ledge in a secure location.
7.
Repair/replace landing ledge as needed.
8.
Reverse procedure to reinstall.
Connector
Screw
Screw
Screw
Griddle Module
Summary of Contents for VDSC530 Series
Page 124: ...Wiring and Schematics Wiring Schematic VDSC530T 4B 124 2010 Viking Preferred Service ...
Page 125: ... 2010 Viking Preferred Service 125 Wiring and Schematics Wiring Schematic VDSC536T 4G ...
Page 126: ... 2010 Viking Preferred Service 126 Wiring and Schematics Wiring Schematic VDSC536T 4Q ...
Page 127: ... 2010 Viking Preferred Service 127 Wiring and Schematics Wiring Schematic VDSC536T 6B ...
