Viking VDSC530 Series, Service Manual

Page: 45 / 132

© 2011 Viking Preferred Service
45
Service Diagnostics and Procedures
Offset Temperature Adjustment–both ovens (continued)
Now, depress the ”SELECTOR KNOB” and the 0° will begin to flash. Rotate the ”SELECTOR KNOB” towards
the right until the following is in the display:
By bringing the offset > you will actually increase the temperature by 30°F. The opposite would be true if the
temperature is 30°F too high, then you would need to adjust the offset < by -30°F.
Diagnostics and Testing
Check Control Version and Entering Diagnostic Mode
To check control version and enter Diagnostic mode:
1. Press “CLEAR/SETTINGS” button and hold three seconds to activate.
Ó°ÊÊ Êii«Ê̜}}ˆ˜}ÊÌ iÊ»-/",Ê " »Ê̜ÊÌ iÊÀˆ} ÌÊ՘̈Ê8/Êà œÜÃʈ˜ÊÌ iÊÀˆ} ÌÊ`ˆÃ«>ްʜ`Ê
”SELECTOR KNOB” to the right two seconds until one beep is heard.
3. Within three seconds, press “OVEN FUNC,” “OVEN TEMP,” “OVEN FUNC”.
4. When Diagnostic mode is entered successfully you will see VERSION 16 in the display.
To exit the diagnostics at any time, press the “OFF” or the “CLEAR/SETTINGS” button.
Note: You must be in the Settings mode and in the EXIT screen to access the diagnostic mode.
Note: If you do not see VERSION, you have not entered the Diagnostic mode. Re-enter the steps above until
you have successfully entered.
Note: 16 is the current software version.
+30°F
OFFSET
CLOCK/
PROBE
OVEN
FUNC
OVEN
TEMP
OFF
CLEAN/
SETTINGS
MIN/SEC
TIMER
SET
STOP TIMER NO PROBE
COOK TIME ON DELAY
HR MIN
COOK
TIME
STOP
TIME
AM
PM
888°8
88:88
00000000
CLEAR/
SETTINGS
CLOCK/
PROBE
OVEN
FUNC
OVEN
TEMP
OFF
MIN/SEC
TIMER
SET
STOP TIMER NO PROBE
COOK TIME ON DELAY
HR MIN
COOK
TIME
STOP
TIME
AM
PM
16
88:88
VERSION
CLEAR/
SETTINGS