VIKING GARDEN MT 4097 S, Instruction Manual

Page: 45 / 306

EN
NO
43
SV
FI
DA
PL
0478 192 9804 B - EN
Unscrew the nut (1) from black connection
cable (2) using two A/F 8 spanners and
remove the screw (3), washer (4) and
nut (1).
Detach and remove the black connection
cable (2) from the battery negative (–)
terminal.
Detach cap (5). Unscrew the nut (1) of the
red connection cable (6) from the battery
positive (+) terminal using two A/F
8 spanners and remove. Remove the
screw (3), washer (4) and nut (1).
Remove the red connection cable (6) from
the battery positive (+) terminal.
● Remove the battery if necessary.
● Reattach screws, washers and nuts to
the battery negative (–) and positive (+)
terminals for safe keeping.
● Close the battery compartment if
necessary. (
Ö
14.17)
Connecting the battery:
● Set the battery down.
● If necessary, remove the bolts, washers
and nuts from the battery.
Positive terminal (+): Attach the terminal
connector of red connection cable (6) to
the battery positive terminal with bolt (3),
washer (4) and nut (1).
Tighten the connection using two A/F8
spanners.
Tightening torque: 4 - 5 Nm
Fit cap (5) to completely cover the
connection.
Negative terminal (–): Attach the terminal
connector of black connection cable (2)
with bolt (3), washer (4) and nut (1) to the
battery negative terminal.
Tighten the connection using two A/F8
spanners.
Tightening torque: 4 - 5 Nm
● Insert the battery.
Removing the battery:
● Disconnect the battery. ( Ö 14.18)
● Pull out the battery.
Inserting the battery:
● Open the battery
compartment. (
Ö 14.17)
● Connect the battery. ( Ö 14.18)
Check the charge state before
installing the battery.
If the minimum voltage is not
achieved, fully recharge the battery
using a battery charger before
installation.
Minimum voltage: 11,5 V