VIKING GARDEN MT 4097 S, Instruction Manual

Page: 40 / 306

0478 192 9804 B - EN
38
Lifting and supporting the machine:
● Park the machine on firm and level
ground and secure it against rolling
away.
● Stop the engine. (
Ö
12.3)
● Engage the parking brake. ( Ö 8.12)
● Remove the ignition key and keep it in a
safe place.
Front axle: A > 230 mm
Rear axle: B > 210 mm
Removing the wheel:
Detach cap (1).
Remove retaining ring (2) using a
screwdriver.
Remove large washer (3) and small
washer (4) (only fitted on rear wheel).
Remove wheel (5) from the axle.
Installing the wheel:
The following points must be observed
before installing the wheels:
● Remove dirt from the wheel axle.
● Lightly coat the wheel axle with grease
before installation.
Risk of injury!
Bear in mind the weight of the
machine when lifting it (see section
"Technical specifications"). (
Ö 21.)
If necessary, raise the machine with
the help of a second person or
using a jack (not included in the
standard equipment).
Secure the machine against rolling
away before lifting.
The brake only acts on the rear
wheels. Secure the machine
against rolling away when lifting the
rear axle.
Avoid damage to the machine!
When supporting, ensure that only
the axle or the rear panel of the
machine contacts the trailer
coupling.
Only lift the machine at suitable
components (e.g. frame, rims,
axle). Never lift or support the
machine at plastic parts.
When removing the rear wheels,
ensure that the couplers (feather
keys) are not lost.
Before installing the rear wheels,
ensure that the couplers (feather
keys) are located in the grooves of
the wheel axle on both sides.
When mounting the wheels, ensure
that the valves are always located
on the outside.