ViewZ RTDVR series, User Manual

Page: 113 / 136

113 | P a g e
APPENDIX
How to set the IP address of the DVR and open TCP port of the router?
The port forwarding steps will vary depending on the brand and model of the router. Port Forwarding is required to
access the DVR remotely. (NOTE: Please check your router’s User’s Manual for detailed instructions on Port
Forwarding)
1. Default network setting on DVR are
-
Port: 5445
-
WEB Port : 80
- Network : DHCP
2. From a PC connected to the same Router as the DVR, select start>run>cmd to open the command prompt.
In the command prompt, type “ipconfig” to find the following information; IP Address, Subnet Mask, and
Default Gateway.
3. Open the default DVR port 5445 and the Default Web Port 80 on the router if the DVR’ s NETWORK TYPE is
set to DHCP. If the DVR’ s NETWORK TYPE is set the LAN, input the following information in the DVR; IP
Address, Subnet Mask, and Default Gateway.