40
Overload protection
If the tolerance range of the electronic soft starter is
exceeded, the soft starter will automatically separate
the appliance from the mains.
Remove the cause if the relay has responded. The
relay does not need to be reset.
Starting characteristics
The starting characteristics are set at the DIP switches
behind the transparent protective flap of the electronic
soft starter. At the factory, the DIP switches are set to
suit the respective heat pump type.
Prior to commissioning, compare the DIP switch set-
tings with the details in the separate "Connection and
wiring diagram", and adjust if necessary.
Explanation of the LED indicators (number of flashes)
HOLD TO TEST
PUSH TO RESET
SMC-3
OVLD SETTING
LED STATUS
ON RUN/ON
RUN/FAULT
A1 A2 IN1 IN2 97 98 13 14
1 OLVD
2 TEMP
3 PHASE REVERSAL
4 PHASE LOSS/OPEN LOAD
5 PHASE IMBALANCE
6 SHORTED SCR
7 TEST
L1
L2
L3
T1
T2
T3
Fig.25
1 Overload
2 Excess temperature
3 Phase reversal
4 Phase loss / motor not connected
5 Phase asymmetry
6 Short-circuited Thyristor
7 Test
Installation sequence
Power supply
(cont.)
5549 991 GB
Installation
Summary of Contents for 301.BS090
Page 99: ...99 5549 991 GB...
