Videotec MAXIMUS MVX, Instruction Manual

Page: 33 / 256

Instruc
tion manual - English - EN
31 MNVCMVXCAM_1645_EN
9 Maintenance
The pre-installed camera can only be
replaced with one of the same brand and
model.
Read the product HANDBOOK before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.
9.1 Firmware updating
The H.264 encoder firmware can be
upgraded directly from the web interface.
If necessary, the device and video encoder firmwares
can be updated.
The firmware update operation can be performed
remotely (VIDEOTEC MACRO and PELCO D protocols
only) using a USB/485 Serial converter (not included
in the pack). This option is only available for the
analogue versions of the product.
For further information please contact the VIDEOTEC
service center.
9.1.1 Factory Default
It is possible to reset to the factory default settings.
Follow the procedure below:
• Power the unit. Wait for 2 minutes.
• Connect the signal cable grey and green wires
(Tab. 3, page 8).
• Wait for 2 minutes.
• Switch off the unit.
Disconnect the previously connected green and grey
wires.
• Power the unit.
In the IP version of the product, enter the
address 192.168.10.100 to access the device
via a web interface.
10 Disposal of waste
materials
This symbol mark and recycle system
are applied only to EU countries and not
applied to other countries of the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.