Victron energy MultiPlus 12/3000/120 - 50, Manual

Page: 47 / 62

43
E
N
A
p
p
e
n
d
ix
Code Meaning: Cause/solution:
1 Device is switched off because one
of the other phases in the system
has switched off. Check the failing phase.
3 Not all, or more than, the expected
devices were found in the system. The system is not properly configured.
Reconfigure the system.
Communication cable error. Check the cables
and switch all equipment off, and then on again.
4 No other device whatsoever
detected. Check the communication cables.
5 Overvoltage on AC-out. Check the AC cables.
10 System time synchronisation
problem occurred. Should not occur in correctly installed
equipment. Check the communication cables.
14 Device cannot transmit data. Check the communication cables (there may be
a short circuit).
16 System is switched off because it is
a so-called extended system and a
‘dongle’ is not connected. Connect dongle.
17 One of the devices has assumed
‘master’ status because the original
master failed. Check the failing unit. Check the communication
cables.
18 Overvoltage has occurred. Check AC cables.
22 This device cannot function as
‘slave’. This device is an obsolete and unsuitable
model. It should be replaced.
24 Switch-over system protection
initiated. Should not occur in correctly installed
equipment. Switch all equipment off, and then
on again. If the problem recurs, check the
installation.
25 Firmware incompatibility. The
firmware of one the connected
devices is not sufficiently up to date
to operate in conjunction with this
device. 1) Switch all equipment off.
2) Switch the device returning this error
message on.
3) Switch on all other devices one by one until
the error message reoccurs.
4) Update the firmware in the last device that
was switched on.
26 Internal error. Should not occur. Switch all equipment off, and
then on again. Contact Victron Energy if the
problem persists.