35
E
N
A
p
p
e
n
d
ix
Step 2: Exemplary setting for parallel mode
In this example, the master is configured according to factory settings.
The slaves do not require setting!
To store the settings after the required values have been set: press the 'Down' button
of the
master
for 2 seconds (
lower
button to the right of the DIP switches).
The
temperature and low-battery LED’s will flash to indicate acceptance of the
settings
.
You can then leave the DIP switches in the selected positions, so that the ’other
settings’ can always be recovered.
To start the system: first, turn all devices off. The system will start up as soon
as all devices have been turned on.
Master
Slave 1
Slave 2
DS-8 Ch. voltage(GEL 14,4V)
off
DS-7 Ch. voltage(GEL 14,4V) on
DS-6 Absorption time (8 h)
on
DS-5 Adaptive charging (on)
on
DS-4 Dyn. current limit (off)
off
DS-3 UPS function (on)
on
DS-2 Voltage (120V)
on
DS-1 Frequency (60Hz)
off
DS-8 na
DS-7 na
DS-6 na
DS-5 na
DS-4 na
DS-3 na
DS-2 na
DS-1 na
DS-8 na
DS-7 na
DS-6 na
DS-5 na
DS-4 na
DS-3 na
DS-2 na
DS-1 na
Summary of Contents for MultiPlus 12/3000/120 - 50
