Victory Motorcycles 2011 Cross Country, Rider'S Manual

Page: 75 / 126

71
Maintenance
Rear Brake Pedal
1. See page 34 for rear brake pedal adjustments.
2. Lubricate the pivot bushing at the intervals recommended in the periodic maintenance
table beginning on page 55. Also lubricate any time binding is evident. Use VICTORY
All Purpose Grease or equivalent.
3. Inspect brake pads as outlined on page 41.
Brake Fluid Precautions
Using the wrong fluid or allowing air or contaminants into the fluid system can damage the system
seals or result in a malfunction that could lead to serious injury or death. Use only DOT 4 brake fluid
from a sealed container.
Do not operate the front brake with the reservoir cover removed. Fluid could overflow from the reservoir
and allow air to enter the system. Air in the brake system could cause the brakes to malfunction.
An over-full reservoir may cause brake drag or brake lock-up, which could result in serious injury or
death. Maintain brake fluid at the recommended level. Do not overfill.
NOTICE: Brake fluid will damage painted surfaces and plastic parts. Always clean spilled brake fluid
immediately with water and a mild detergent.
Rear Brake Fluid
1. Position the motorcycle on level ground in the fully
upright position.
2. The rear brake fluid reservoir is located near the rear
brake pedal, just inside the right lower leg fairing. Wipe
the fluid container and the area around the reservoir
cover with a clean cloth.
3. If the fluid level is low, inspect brake pads as outlined on
page 41. If pads are not worn beyond the service limit,
inspect the brake system for leaks.
4. To add fluid, remove the reservoir cover. Carefully add
fluid to the recommended level. Do not overfill.
5. Reinstall the cover and diaphragm.
6. Wipe away any fluid spills. Check for signs of brake
fluid leaks around hoses, fittings, reservoir, and brake
calipers.
WARNING
Maximum
Mark
Minimum
Mark