Victory Motorcycles 2011 Cross Country, Rider'S Manual

Page: 24 / 126

20
Instruments, Features and Controls
Instrument Cluster (CROSS ROADS)
Speedometer
The speedometer displays vehicle speed in either
miles per hour (MPH) or kilometers per hour (km/h).
Indicator Lamps
Lamp Indicates Condition
Neutral This lamp illuminates when the transmission is in neutral and the ignition
key is in the ON position.
High Beam This lamp illuminates when the headlamp switch is set to high beam.
Turn Signal The turn signal indicator flashes when the left, right, or both turn signals
(hazard) are active.
If a bulb fails, or if there is a short circuit in the signal
system, the lamp flashes at more than twice the normal rate.
Low Oil
Pressure This lamp illuminates when the ignition switch is in the ON position and
the engine is off, indicating that the indicator circuit is functioning
properly. This lamp also illuminates if engine oil pressure drops below
safe operating pressure. If this lamp illuminates while the engine is
running, turn the engine off as soon as safely possible and check the oil
level.
If the oil level is correct and the lamp remains on after the engine is
restarted, turn the engine off immediately.
Low Fuel This lamp illuminates when approximately one gallon (3.8 liters) of fuel
remains in the fuel tank.
Cruise Control
Engaged Before using the cruise control (if equipped), read the safety and
operation procedures beginning on page 49.
Check Engine This lamp illuminates momentarily when the ignition switch is in the ON
position and the engine is off. This indicates proper function.
If this lamp
illuminates while the engine is running, contact an authorized VICTORY
dealer promptly for diagnosis.
The light will remain on if the tilt sensor
shuts down the engine. See page 32. If abnormal sensor or engine
operation is detected the light will remain on as long as the fault
condition exists. Retrieve the error codes for diagnosis. See page 26.
Speedometer Indicator
Lamps
Multi-Function Display