49
Operation
Braking
Always allow sufficient stopping distance so that brakes can be applied gradually.
Tip:
Applying slightly more front brake than rear brake generally provides the best braking perfor-
mance.
1. To slow the motorcycle with the brakes, close the throttle and apply the front and rear
brakes evenly and gradually.
2. As the motorcycle slows, disengage the clutch, or downshift each time vehicle speed
reaches a downshift point.
WARNING!
Braking improperly could result in loss of control, which could result in serious injury or
death. Avoid braking abruptly. Always apply the brakes gradually, especially on wet, slippery or other
low traction surfaces. Avoid braking in a curve or turn. Bring the motorcycle to the upright position
before applying the brakes.
Using Cruise Control (if equipped)
If equipped, the cruise control is located on the right handlebar.
Read this section and understand how to safely operate this fea-
ture before using the cruise control.
WARNING!
Improper operation of cruise control could cause loss of
control and result in serious injury or death. Follow all cruise operation
procedures carefully. Never use cruise control when roads are wet or
slippery. Do not use cruise control when riding in heavy or congested
traffic.
Cruise Control Tips
• Cruise control can be set in any gear.
• Vehicle speed must be above 25 MPH (40 km/h).
• Set speed will vary slightly in hilly terrain.
• Cruise control will not resume a pre-set speed if the resulting
acceleration or deceleration rate is too high or too low. For example,
resuming a set speed from 40 MPH (64 km/h) while in 6th gear may
cause cruise to disengage.
• Cruise control will not engage if brake lights are not operating properly.
Set Speed
1. Press the cruise control ON button.
Tip:
The cruise control indicator lamp will illuminate when the ON or
OFF switch is pressed.
2. Wait at least 3 seconds. A red dot (power indicator) at the
center of the switch will illuminate to indicate when
cruise control can be engaged.
3. Accelerate to the desired speed and press the SET switch.
The cruise control indicator lamp will illuminate.
Cruise Control
Switches
ON
SET
Power Indicator
Summary of Contents for 2011 Cross Country
Page 1: ...PMS 419 2011 Rider s Manual Victory Cross Country TM Victory Cross RoadsTM...
Page 3: ...The text is printed on 100 recycled with 40 post consumer waste PCW...
Page 5: ...1 2011 Rider s Manual Victory Cross Roads Victory Cross Country...
Page 60: ...56 Maintenance Maintenance Log Maintenance Performed Miles Km Notes Performed by...
