34
Instruments, Features and Controls
Pedal Adjustment
The brake pedal and gear shift pedal controls can be
adjusted to a front, rear or center position. The center
position is the factory setting.
1. Remove the screw from the footwell support.
Tool:
6 mm Allen wrench
2. Slide the control forward or rearward in its track
until the threaded hole of the control aligns with
the desired hole in the footrest support.
3. Reinstall the screw.
Torque: 96 in-lbs (11 Nm)
4. After adjusting the shift pedal, always readjust the
shift linkage rod. Loosen both jam nuts on the
linkage and turn the shaft until the footpeg is about
90 mm from the floorboard (or to desired height).
Tighten both jam nuts.
Torque: 96 in-lbs (11 Nm)
Sidestand
The sidestand is located on the left side of the motorcycle.
WARNING!
An improperly retracted sidestand could contact the
ground and cause a loss of control resulting in serious injury or
death. Always retract the sidestand fully before operating the
motorcycle.
To park the motorcycle, swing the end of the sidestand down-
ward and away from the motorcycle until it is fully extended.
Lean the motorcycle to the left until the sidestand firmly sup-
ports the motorcycle.
To retract the sidestand, straddle the motorcycle and bring it
to the fully upright position. Swing the end of the sidestand
upward and toward the motorcycle until it is fully retracted.
Center Adjustment
Position
Summary of Contents for 2011 Cross Country
Page 1: ...PMS 419 2011 Rider s Manual Victory Cross Country TM Victory Cross RoadsTM...
Page 3: ...The text is printed on 100 recycled with 40 post consumer waste PCW...
Page 5: ...1 2011 Rider s Manual Victory Cross Roads Victory Cross Country...
Page 60: ...56 Maintenance Maintenance Log Maintenance Performed Miles Km Notes Performed by...
