112
CB Radio / ICOM System
ICOM System
Press and release
ICOM on the left
control to activate
the intercom sys-
tem.
When the inter-
com system is active, ICOM will display on
the console screen.
VOX Break Setting
The intercom is opened and closed using a
voice-operated switch (VOX). The volume
sensitivity level required to open the inter-
com can be adjusted using the VOX sensi-
tivity setting.
Press and hold
ICOM on the
upper left control
to access the VOX
sensitivity set
screen.
Push COM or ICOM to adjust the sensitiv-
ity setting.
Tip:
Lower settings require less volume to open
the intercom. If wind or ambient vehicle
noise trigger the VOX to open, set the VOX
sensitivity to a higher level.
“VOX” will display on the console screen
whenever the driver or passenger are com-
municating over the intercom system.
Driver ICOM Volume
To change settings, enter the mode menu.
Press TUNE (+) or TUNE (-) to adjust
settings.
Tip:
Intercom volume can also be adjusted with
the hand control when the VOX circuit is
open.
Passenger ICOM Volume
Press (+) or (-) on the headset control to
raise or lower volume.
Headset Receptacles
The driver's headset receptacle is located on
the left side of the motorcycle below the
fuel tank.
The passenger headset receptacle (if
equipped) is located on the left side of the
motorcycle on the forward side of the sad-
dlebag.
FM
ICOM
CB19
92.5
COM
+/-
ICOM
VOX 15
100.5
FM
VOX
CB19
+
TUNE
-
ICOM VOL 15
Summary of Contents for 2011 Cross Country
Page 1: ...PMS 419 2011 Rider s Manual Victory Cross Country TM Victory Cross RoadsTM...
Page 3: ...The text is printed on 100 recycled with 40 post consumer waste PCW...
Page 5: ...1 2011 Rider s Manual Victory Cross Roads Victory Cross Country...
Page 60: ...56 Maintenance Maintenance Log Maintenance Performed Miles Km Notes Performed by...
