Victor ULTRA-CUT 200, Operating Manual

Page: 41 / 168

Manual No. 0-5133 3-15 INSTALLATION
ULTRA-CUT 200
3. Feed the Fiber Optic Cable plug and wires through the hole where the plastic plug was removed labelled
GCM/DCM and slide the thin nut back over the Fiber Optic Cable.
4. Secure the thin nut on the through hole protector so both nut faces are tight against the sheet metal inside
and out.
5. Plug the Fiber Optic Cable into the PCB as shown below. Make sure the locking tabs are engaged.
Thi n nu t s ec ur i n g
the th r o u gh hole
p r otecto r
Fibe r Optic
Cable
Pl
u g
A r t # A-09136
6. Notice the alignment pin and then connect the TSC-3000 cable (V) to the rear of the CCM as shown below.
TSC-3000 Cable
DMC-3000 Fiber
Optic Cable
A r t # A-09137