6.
Lubricate the upper roll with No . 2EP Lithium
base grease as shown . Refer to maintenance
section for additional information .
NOTICE
• As the upper support block bolt is
tightened, it will draw the upper roll
assembly into proper alignment with the
lower roll.
COPPER ROLL INSTALLATION 2 - 6” AND 8”
Installation and removal of 2 - 6” roll set for
copper tubing is identical to installation and
removal of standard roll set for 2 - 31/2” steel
pipe . See page 22 .
Installation and removal of 8” roll set for copper
tubing is identical to installation and removal
of standard roll sets for 4 - 16” steel pipe . See
page 21 .
MAINTENANCE PROCEDURES
GENERAL
This manual provides information to permit
the operator of Series 416 tools to keep his
equipment in top operating condition and to
guide him in making repairs when it becomes
necessary .
Replacement parts, applicable only to these
tools, should be ordered from Victaulic to assure
proper operation of the tool . All special parts are
FOB Easton, Pennsylvania, at the price in effect
at the time of ordering .
NOTICE
• Remember that preventative maintenance
during operation will pay for itself in
repair and operating savings.
DANGER
• Before performing any
repair or maintenance,
disconnect the tool from
the electrical source to
prevent accidental start
up of tool.
Failure to do so could result in death or
serious personal injury.
After every eight hours of operation lubricate the
tool . Always lubricate upper roll bearings when
rolls are changed .
1.
Grease slide gibs . Two grease fittings are
provided as shown .
2.
Grease upper roll bearing at fitting provided
as shown .
TM-VE416FS/FSD_23
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A
