4
XX207-00-02 Rev 910 MP-980DN Camera
2. The camera allows the transmission of power and data via a single Ethernet cable (the Ethernet cable should
meet the specs of UTP Category 5 and not
exceed 100 meters in length)
. When powering with PoE, connect
camera’s Ethernet port to an Ethernet (RJ-45) connector. If the camera has built-in PoE, it can be
regard as a Powered Device (PD) and connect it directly to a Power Sourcing Equipment (PSE) device,
such as a PoE switch.
3. Connect a PC to the Ethernet hub (RJ-45 connector).
If using the screw terminal for digital input for alarm sensors, follow the diagram below. Digital output is not
supported by ViconNet.
Upon power up, the status LED lights and then the device will go through a booting process. Refer to the
table below for LED status descriptions.
