Vertical SUMMIT IP, User Manual

Page: 68 / 70

Release 1.0 SUMMIT
IP Station User Guide April 2014
Using a Bluetooth Wireless Headset (IP-8024 only) B-3
Appendix B: IP PHONE SETUP
When using a Headset, the [SPEAKER] button controls the ON/OFF-hook state for the phone.
To use the Speakerphone to answer or place a call:
Press [SPEAKER], the phone goes off-hook and sends audio to the speaker and
the microphone.
To control the volume of the Speakerphone or handset:
Press the [VOLUME Up/Down] button.
To Mute the microphone:
Select the [MUTE] button.
To turn off Mute (turn the microphone ON):
Press the [MUTE] button.
To activate Group Listen while on an active handset call:
Press the [SPEAKER] button.
Using a Bluetooth Wireless Headset (IP-8024 only)
The SUMMIT IP- 8024 may be equipped with a Bluetooth Unit (BTU) allowing you to use a
wireless headset that supports Bluetooth version 2.0. Using a headset permits you to move freely
around the phone (within approximately 10 meters) and maintain a conversation. Before using the
headset, the headset must be "paired" with the BTU, and then the headset must be enabled for
use. Operation of the SUMMIT IP-8024 with the headset is the same as with the Speakerphone;
press the [SPEAKER] button to activate the BTU to go ON and OFF-hook.
NOTE
:
When in pairing mode, the phone and the Bluetooth unit should be within 1 meter proximity.
To pair the wireless headset to the BTU:
1. Press the [HEADSET] button,
2. Dial 3,
3. Press the [HOLD/SAVE] button.
To enable/disable the wireless headset:
1. Set the Bluetooth headset to pairing mode,
2. Press the [TRANS/PGM] button,
3. Dial 4,
4. Dial 1(enable).
5. Press the [HOLD/SAVE] button,