Vertical SUMMIT IP, User Manual

Page: 22 / 70

Release 1.0 SUMMIT
IP Station User Guide April 2014
Conditions
1. The saved number can be a maximum of 23 digits.
2. Dialing the saved number will automatically seize the outside Line that was used for
the original call. If the Line is busy, a Line from the same group will be selected and the
saved number dialed. If all Lines from the group are busy, you will receive the All Lines
busy tone and may queue.
3. If you press the [HOLD/SAVE] button after seizing a Line without dialing, the Save
Number Redial buffer will be erased.
4. If there is no {LINE} button, the call will be presented on a {POOL} , or {LOOP} button.
5. Save Number Redial is protected from power failure.
6. Manually dialing a Flash during an outside Line will cause only those digits after the
Flash to be stored and re-dialed as the Save Number Redial.
Using System Speed Dial Numbers
The system has memory allocated for 4000 Station Speed Dial numbers
– 100 per station
(bins 000-099). The system has memory allocated for 3000 System Speed Dial numbers
(bins 2000-4999).
You may, if allowed, use System Speed Dial to call frequently dialed numbers.
In some cases, these numbers are divided into groups called System Speed Zone Groups.
In this case, you may access some numbers and not others and your dialing restrictions may
be invoked.
Only an Attendant can assign System Speed Dial numbers.
To dial using a System Speed Dial using a [SPEED] button
2. Press the [SPEED] button.
3. Dial the desired bin number (2000-4999)
To dial a System Speed Dial number using an LIP-8000 series phone with soft buttons
1. Press the [DIR] soft button.
2. Press the [SPEED] soft button.
3. Dial the desired bin number (2000-4999)
SLT
To dial using a System Speed Dial
1. Lift handset.
2. Dial “558”, the SLT Speed Dial access code.
3. Dial the desired bin number (2000-4999)
.