21
SG71070M
Revision A3
2-4.2.2 IP Source Guard
The section describes how to configure the IP Source Guard detail parameters of the switch.
You could use the IP Source Guard configuration to enable or disable a port of the switch.
2-4.2.2.1 Configuration
This section describes how to configure IP Source Guard settings including
：
Mode (Enabled and Disabled)
Maximum Dynamic Clients (0, 1, 2, Unlimited)
Web Interface
To configure an IP Source Guard Configuration in the web interface:
1.
Select “Enabled” in the Mode of IP Source Guard Configuration.
2.
Select “Enabled” of the specific port in the Mode of Port Mode Configuration.
3.
Select Maximum Dynamic Clients (0, 1, 2, Unlimited) of the specific port in the Mode of
Port Mode Configuration.
4.
Click Apply.
Figure 2-4.2.2.1: The IP Source Guard Configuration
Parameter description:
Port Mode Configuration
Specify IP Source Guard is enabled on which ports. Only when both Global Mode and Port
Mode on a given port are enabled, IP Source Guard is enabled on this given port.
Max Dynamic Clients
Specify the maximum number of dynamic clients that can be learned on given port. This
value can be 0, 1, 2 or unlimited. If the port mode is enabled and the value of max dynamic
client is equal to 0, it means only allow the IP packets forwarding that are matched in static
entries on the specific port.