VeriFone Omni 3200SE, Installation Manual

Page: 14 / 36

T
ERMINAL
S
ETUP
Install Paper Roll
14
I
NSTALLATION
G
UIDE
Figure 6 Pass-Through Connection
A pass-through telephone line connection can save the cost of an additional
dedicated or leased line, but there are several disadvantages to using a pass-
through connection:
•
Normal calls cannot be made while the terminal is processing a transaction, or
when a remote host computer is dialing in to the terminal.
•
Lifting the telephone handset during a transaction can disrupt the audible data
carrier signal and cause the terminal transaction to fail.
Optional Swivel
Stand
VeriFone produces an optional swivel stand for Omni 3200
SE
/3210
SE
terminals
Some terminals come with the swivel stand already attached, with two pre-
installed “pigtail” cables to allow convenient connection of the power cable and
telephone line cord without removing the swivel stand.
To set up a direct connection using the pigtail cable:
•
Insert the connector on one end of the telephone line cord into the modular
RJ-11 female jack on the end of the telephone line pigtail.
•
Insert the connector on the other end of the cord into a nearby RJ-11
telephone wall jack.
•
To configure a pass-through connection for a terminal with attached swivel
stand, the stand must be removed, then re-attached. The procedure for
removing and reattaching the swivel stand is described in the
Omni 3200
SE
/
3210
SE
Stand Quick Installation Guide, (VPN - 22880).
Install Paper
Roll
A fast, quiet thermal printer is built-in to the Omni 3200
SE
/3210
SE
terminal.
Before processing transactions that require a receipt or record, you must install a
roll of thermal-sensitive paper in the printer.