INSTALLATION GUIDE
13
REMOVE OEM DOOR AND PARTS
REVISION™ Door for National 157/167 - 158/168
Remove coin chute screws from existing cash box housing
and cabinet.
Remove all harnessing from controller and interface boards.
Save standoffs and hardware from both boards and set aside
for future installation of power supply board.
Loosen 1/4” screws from top and bottom of panel and lift off.
Then, using a Phillips or flat head screwdriver (depending on
machine), remove the (4) screws that hold (2) OEM lock bar
latches in place.
14
16
15
17
NOTE:
It is recommended to retain all “P” shaped clamps
for future use to secure new wiring with new controller
assembly, and to maintain a cleaner application.
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSING
INS
TALL BUCKET
DROP SENSOR
ADJUS
T DOOR
Controller Board
Pay Side of the
Cabinet
Interface Board
Cash Box
Screws (2)
Coin Chute
OEM Lock Bar
