INSTALLATION GUIDE
17
REVISION™ Door for National 157/167 - 158/168
INSTALL REVISION DOOR
Next, disconnect existing power harness as shown.
Then, connect the
Power Adapter Harness (VE1015729)
to
the male connector as shown.
Next, guide harness through the opening as shown above on
the left image. Then, route harness upward behind cabinet
weldment and push through cutout as shown in right image.
Next, from inside the cabinet, re-install the cover to the main power supply (left, right
images). Ensure that all wires are not pinched and are contained behind the main
power supply cover.
Then, connect the female end of the power adapter harness
from the rectangular cutout to the power supply board
connector as shown.
11
12
13
14
15
SECTION 2. DOOR COMPONENTS (continued)
THIS SECTION IS COMPLETE,
MOVE TO HARNESSING ON THE
NEXT SECTION
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSING
INS
TALL BUCKET
DROP SENSOR
ADJUS
T DOOR
Power Adapter Harness
Male Connector
Power Adapter Harness
Panel Hole
Panel Cutout
Power Supply
Power Adapter Harness
Connections
