INSTALLATION GUIDE
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSING
INS
TALL BUCKET
DROP SENSOR
ADJUS
T DOOR
11
REMOVE OEM DOOR AND PARTS
REVISION™ Door for National 157/167 - 158/168
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSING
INS
TALL BUCKET
DROP SENSOR
ADJUS
T DOOR
Remove bucket guard at the top of the Vend Bucket by loosening
(2) screws on left and right side.
Using a 7/16” nut driver or socket, remove door
stop from bottom of door. Set aside to install on
REVISION door.
Lift up and remove the door.
Using a 7/16” socket, remove the top hinge from inside the door (left). A flat
head screwdriver may also be required (right).
5
6
7
9
8
Right Side
Vend Bucket
Then, remove the screws holding Vend Bucket to the door on
both sides. Up to (4) screws could be fastened to each side.
Remove the OEM Vend Bucket from the door.
(Continued next page)
CAUTION
USE AN ADDITIONAL
PERSON WHEN
REMOVING THE DOOR TO
PREVENT INJURY TO THE
INSTALLER AND DAMAGE
TO THE EQUIPMENT
Vend Bucket
Linkage
Socket Wrench
Door Stop Arm
Bottom of Door
Top of Door
CAUTION
TO AVOID PERSONAL INJURY, MAKE SURE
THE OEM DOOR IS SUPPORTED
Socket Wrench
Left Side
Bucket Guard
