INSTALLATION GUIDE
10
REMOVE OEM DOOR AND PARTS
REVISION™ Door for National 157/167 - 158/168
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSING
INS
TALL BUCKET
DROP SENSOR
ADJUS
T DOOR
If equipped with an OEM Gum and Mint tray, use a 3/8” nut
driver or socket set, remove (2) bolts, one on each of the
Vend Bucket.
If present, remove the validator and coin
mechanism. If they are MDB, set them aside for
future installation.
Disconnect the gum and mint tray harness from jumper board
on tray motor mount at the bottom of the Vend Bucket.
Using a 1/4” nut driver or socket set on the top screw, remove the bucket
deflector on the left side of the Vend Bucket. Use 11/32” nut driver or socket
for two side screws.
1
3
2
4
TO AVOID POTENTIAL
INJURY, IT IS HIGHLY
RECOMMENDED THAT
THE CURVE DOOR IS
INSTALLED BY TWO
QUALIFIED INSTALLERS
DO NOT REMOVE THE
TRAYS FROM THE
CABINET. THE CABINET
COULD BECOME
UNSTEADY AND RESULT
IN DAMAGE OR
PERSONAL INJURY
TO PREVENT
PERSONAL INJURY AND
EQUIPMENT DAMAGE,
TURN MACHINE OFF
AND DISCONNECT
ELECTRICAL CORD FROM
THE WALL OUTLET TO
PREVENT ELECTRICAL
SHOCK
TEST THE MACHINE THAT
IT IS WORKING ORDER
BEFORE REPLACING THE
DOOR. SERVICE SHOULD
BE PERFORMED BY
QUALIFIED PERSONNEL
NOTICE
WARNING
WARNING
CAUTION
Screws on Left Side
Gum and Mint Tray
Screws Holding
Gum and Mint
Tray
Vend Bucket
Jumper Board
(Continued next page)
Card Validator
Deflector
Harness
