2.2.4.2.1 LLC-BRG, LLC-RTE, and CLIP Mode PING Results
After configuring, press F3 to start the test. As the test proceeds,
the test set displays an ‘IN PROGRESS’ message.
• The module will send 10 PINGs at one-second intervals. One
or more responses from the destination is considered a pass.
Refer to the following figure for a pass sample.
12:30:55
>LINK UP
4W STU-R<
ST:12:30:10
ET:00:00:45
LOCAL IP:207.181.199.178
DEST IP :207.181.199.177
PING TEST
PING
: PASS
PING
STOP
Figure 10 LLC PING Test Passed
• ‘PING PASS’ means the destination has received the PING
message and properly responded to the module. This indicates
that the module can connect to the Internet.
• If the test set receives no response, it will display ‘PING FAIL’.
This indicates that either the destination did not receive the
PING message or it did not reply.
• Press F4 to stop the test, press it again to restart testing.
• Press F1 to PING the DEST IP again after PING: PASS is
displayed.
In addition to the test results, the screen also reports:
ET
: Elapsed Time since the test was started or restarted.
ST
: Start Time of the test.
LOCAL IP
: Provides the local IP address for the module. For
LLC-BRG static and LLC-RTE, this is the exact LOCAL IP address
entered in the configuration screen. For LLC-BRG DHCP, LOCAL
IP shows all zeros until the DHCP server assigns an IP address.
When assigned, the LOCAL IP line will display this address.
DEST IP
: Provides the destination IP address for the PING mes-
sages. This is determined in the configuration screen.
MTT-14B e_Manual D07-00-083P RevA00
Page 19 of 101
