VDO CONTISYS OBD -, Instruction Manual

Page: 55 / 144

FastCheck
53
FastCheck Service
Connection
Using the Vehicle Application List on the CD-ROM, identify the required interface cable
for the vehicle system to be tested. Connect the cable to the service tool and secure
the fixing screws.
Note: If the vehicle being tested is a BMW fitted with both a 20 pin connector and an
EOBD (J1962) connector, you must only use the 20 pin connector.
Note: If the vehicle being tested is a Mercedes fitted with both a 38 pin connector and
an EOBD (J1962) connector, you must only use the 38 pin connector.
If using the EOBD (J1962) pin-switchable cable (A2C59512073), ensure the settings
on the switch box correspond to the settings listed for the vehicle and system being
tested.
WARNING: Incorrect settings on the switch box may cause irreparable damage to
the vehicle's electrical system.
Ensure the vehicle's ignition is OFF.
Connect the service tool to the required vehicle connector, refer to ‘Diagnostic
connector locations’, page 79 , for further information.
Power for the service tool is provided by the vehicle connector. Once connected, the
service tool will perform an internal self test and then the screen will display the version
of the current software before displaying the main menu.
MAIN MENU
1. EOBD
2. FastCheck ABS
3. FastCheck Airbag
4. FastCheck Climate
5. FastCheck EPB
6. FastCheck SAS
7. FastCheck Service
8. FastCheck TPMS
9. User Menu
A
B
C
D
E
F
G
H
I
J
K
L
1
2
3
4
5
6
7
8
9
10
11
12
CON0017