VDO CONTISYS OBD -, Instruction Manual

Page: 39 / 144

FastCheck
37
Ford Galaxy (2006-), Mondeo (2007-), S-Max (2006-):
There are three options in the PBM/EPB function menu which can be used to access
various functions:
Service Brakes
There are three functions available under the ‘Service Brakes’ menu option:
Enter Maintenance Mode
This function is used to put the system into a state that enables work to be carried out
by the technician.
The Control Module puts the calipers into a state where normal operation is inhibited
and the callipers can not be closed by any means.This function must be used if
replacement of the brakes, discs or brake pads is to be carried out.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
This function takes 30 seconds to complete.
Note : After this function has been performed the EPB calipers can not be closed and
are inhibited until exit maintenance mode is run. Cycling the ignition, disconnecting the
battery or diagnostics tester does not exit maintenance mode.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Exit Maintenance Mode
This function is used to put the system back into an operational state after work has
been carried out by the technician. Calipers are closed to the applied position, and
normal operation is available again.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
This function takes 35 seconds to complete.
This function also automatically performs an 'Assembly Check', which carries out
internal tests on the Parking Brake system and reports the status (see below). Ensure
the on screen instructions on the service tool are followed precisely and in the correct
order.