VDO CONTISYS OBD -, Instruction Manual

Page: 41 / 144

FastCheck
39
Pre-Test conditions:
• The operator must NOT be inside the vehicle
• The vehicle must be stationary
• The vehicle must be on level ground
• Ensure the vehicle is not subject to any vibration (closing boot, bonnet, etc.)
• The vehicle must be secured with wheel locks
Note : This function cannot be performed while the parking brake system is in
maintenance mode. It should be performed when the system is in normal operating
mode.
Clear Stored Clutch Engagement Point
This function is used to reset the stored value of the clutch engagement point. It
should be used when a new Parking Brake module has been fitted or a new clutch
has been fitted. This function is only applicable to vehicles with manual transmission.
Pre-Test conditions :
• The vehicle must be stationary
• The vehicle must be on level ground
When this function has been performed successfully the Parking Brake module will re-
learn a new clutch engagement point when the vehicle is next driven.
Note : This function cannot be performed while the parking brake system is in
maintenance mode. It should be performed when the system is in normal operating
mode.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Notes on Use of Functions
The four functions are designed to be used in several different situations. Here are a
few situations which may occur and the correct use of the functions to rectify the
situation:
Rear Brake Pad, Brake Disc or Caliper Replacement:
1. If the vehicle requires any of the above components to be replaced the 'Enter
Maintenance Mode' function should be performed.
2. The system will be disabled to allow maintenance work to be carried out easily
and safely.
3. After the work has been carried out the 'Exit Maintenance Mode' function should
be performed.
Inclination Sensor Replacement:
1. After the new sensor has been installed perform the ‘Inclination Sensor
Calibration’ function.