23
12
DISPOSAL
- Do not discard the pump, or any part of it, in the environment.
- Metal parts can be recycled as scrap.
- Greases and oils should be recovered, stored and disposed of through approved agencies in accordance with the regulations
in force in the country where the pump is being used.
- Elastomer gaskets must be kept separate and disposed f through an authorized waste disposal agency in accordance with the
law.
- The battery must be kept separate and disposed of through an authorized collection centre in accordance with the law.
Lastly, remember the Manufacturer will always be glad to help you with necessary assistance and/or spare parts.
INSTRUCTIONS FOR THE USE AND MAINTENANCE -
DUO JD
13
TROUBLESHOOTING, CAUSES AND REMEDIES
WARNING
Before commencing troubleshooting, make sure testing instruments (vacuum gauge, pressure gauge, revolution counter,
ÁRZUHFRUGHUHWFDUHZRUNLQJSURSHUO\
Problem
Cause
Remedy
13.1 Pump does not prime
Delivery pipe under pressure
Bleed delivery pipe.
Pump speed low
Only increase speed once you
have checked the contract data and
pump performance curves.
Impeller may be worn or broken
Disassemble pump casing as
described in section 10.2 and check
impeller for wear
Cutwater (leading edge of the volute) may
be worn
Remove pump casing as described
in section 10.2. Build up the cutwater
with solder and shape it to restore
WKH RULJLQDO SURÀOH ,I FXWZDWHU LV
severely worn, replace the casing.
Suction strainer, where applicable, may be
clogged
Remove obstructions.
Excessive suction lift
Reduce suction lift.
Air entering through seal
Disassemble seal and clean it (see
sect. 10.4); if the problem persists,
replace the seal.
Impeller clogged by foreign matter
Disassemble casing and remove
foreign matter
Slackening or breakage of the vacuum
pump drive belt
Restore belt tension and/or replace
if worn or broken
13.2 Pump does not deliver liquid
Pump does not prime
See causes given in point 13.1.
Head required by the system is greater than
the rated head of the pump
Revise system design or select a
different pump
([FHVVLYH ÁRZ UHVLVWDQFH DORQJ VXFWLRQ
line
Revise distribution of elbows,
valves, constrictions etc.. Where
necessary, increase diameter of
pipework
Impeller clogged by foreign matter
Disassemble casing and remove
foreign matter
Suction/delivery pipes may be obstructed
or clogged
Locate the obstructed or clogged
area and clean
Summary of Contents for DUO JD
Page 4: ...4 Fig 6 Fig 7 Fig 8 Fig 9 OK Fig 11 Fig 10 DUO JD...
Page 57: ......
Page 60: ......
Page 64: ......