Models 947, 948 and 960 Leak Detectors Operations and Service Manual
B-3
B.1.2 Removing the Top Panel
The top panel is one piece that includes the turret and its door, a covering of the sides of the
control and display panel, and the stainless steel top of the 947/948/960.
To remove the 947/948/960 top panel:
1. Remove the upper rear panel.
2. If you need access to the electronics enclosure, remove the service pendant shelf using
the procedure described in “Removing the Service Pendant Shelf” on page B-2.
3. Remove the 3-8 nuts located under the front corners of the frame of the chassis
Figure B-2
The Top Panel at the Rear of the Turret
4. Loosen the test port tightening nut and remove it.
5. Remove the test port plug (Figure B-3), the test port compression ring and the O-ring
from the top of the test port.
NOTE
Do not remove the port nut.
Figure B-3
The Test Port
Location of
Location of
screws holding
the top cover
screws holding
the top cover
Test Port Plug
Do Not Remove: Port Nut
Test Port
Tightening Nut
Summary of Contents for 948
Page 175: ......
