Technical Manual: TM50567
Optica 30/40/50 series
Revision: 4.0
Date of release: 2019-01-23
25/56
www.vareximaging.com
Figure 7 Flange lock
Calibration and collimator setup
This section is only applicable for Optica 40.
For Calibration and Setup of the Optica 30 and 50, see CAN bus Service Protocol Messages, §7.3.
Access to Service screens for calibration and parameter setup
The collimator has 3
Service screens
for calibration, parameter setup and embedded software
revisions. These screens are protected by a password. When the correct password is entered,
Service
screen 1
is displayed.
The next
Service screen
can be entered by selecting the button
.
The previous
Service screen
can be entered by selecting the button
.
Enter the following password code: 7091
Enter passw ord
and select confirm
Passw ord
OK?
YES
NO
